Start the engine and let it idle for two minutes. The Subaru CVT fluid change procedure is as follows:ġ. The specific models and model years included in this service bulletin are: 2012-2014 ImprezaĢ013-2014 Crosstrek 2014 Forester 2013 Outback Subaru has issued a service bulletin #15-90-10 to address a CVT fluid change procedure on certain model-year vehicles. This is because the transmission fluid circulates through the transmission when the engine is running, and checking it while the engine is off will not give you an accurate reading. Yes, you should check your Subaru transmission fluid with the car running. Do You Check Subaru Transmission Fluid With the Car Running? If you notice any unusual behavior from your transmission, such as slipping or jerking, it’s best to have it checked out by a qualified technician as soon as possible. However, even with this extended service interval, it’s important to keep an eye on the condition of your CVT transmission fluid. This is a significantly longer service interval than what is recommended for traditional automatic transmissions, which generally recommend a fluid change between 20,000 and 100,000 miles. The recommended service interval for the Subaru CVT transmission fluid is every 30,000 miles or every 2 years, whichever comes first. Subaru’s CVT transmission is different than most transmissions and as a result, has different service requirements. How Often Should Subaru Cvt Transmission Fluid Be Changed? Finally, put the fill plug back in place and wipe up any spilled fluid with the rag. Next, use the funnel to add new fluid until it starts dripping out of the fill hole. Start by removing the fill plug on the side of the transmission. You’ll need fresh CVT fluid, a funnel, and a clean rag. Replacing the CVT fluid in your Subaru is a simple process that can be done at home with just a few tools. You’ll know it’s time to replace the CVT fluid when your car starts to make strange noises or the transmission begins to slip. Over time, this oil can break down and needs to be replaced. The CVT is filled with a special oil that helps to lubricate the moving parts and keep the transmission running smoothly. Subaru uses a continuously variable transmission, or CVT, in several of its models. Read More About Toyota Cvt Transmission Fluid Change How Do You Fill the CVT Fluid in a Subaru? If it’s below the “low” mark, you’ll need to add more fluid. The fluid should be between the “full” and “low” marks on the dipstick. Reinsert the dipstick all the way into the transmission and then pull it out again to check the fluid level. Remove the dipstick and wipe it clean with a rag or paper towel.Ĥ. On most CVT transmissions, the dipstick will be located near the oil fill cap. Park your car on a level surface and turn off the engine.Ģ. If your car has a CVT transmission, it’s important to check the fluid level regularly. How Do I Check My Cvt Transmission Fluid Level? The fluid should be between the “Full” and “Add” marks on the dipstick if it is at the proper level.Reinsert the dipstick all the way, then remove it again to check the fluid level.Pull out the dipstick and wipe it clean with a rag or paper towel.Locate the dipstick near the front-right side of the engine bay.Park your Subaru on a level surface and set the parking brake.The wrong type of fluid can cause damage to the transmission and may void your warranty. When checking the fluid level in your CVT transmission, it is important to use the correct type of fluid. The check Subaru CVT transmission fluid level is a very reliable transmission, but like all transmissions, it will eventually need to be serviced. As an Amazon Associate, I earn from qualifying purchases.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |